» » How to use electrical wire strippers
Random Video Trending Now

How to use electrical wire strippers

This is a method of stripping wire that one of my friends showed me. I noticed that I use wire for a lot of projects and don't have a wire stripper. This way is useful if you don't have a wire stripper and you're either broke or too lazy to get one. It may seem like it takes a while to do, but once you get used to it it barely takes any time at all. This method is similar to the one by Weissensteinburg , but my friend said that this way may be better for the wire less likely to damage it but I'm not sure. Feedback is always appreciated!
miss philipines porn videogaggers free porn

The Best Wire Strippers (Review) in 2019

lucy li prondebby ryan bare nakedfree teen porn movsgys fucking girl

How to Use Wire Strippers

A wire stripper is a small, hand-held device used to strip the electrical insulation from electric wires. A US-style simple manual wire stripper is a pair of opposing blades much like scissors or wire cutters. The addition of a center notch makes it easier to cut the insulation without cutting the wire. This type of wire stripper is used by rotating it around the insulation while applying pressure in order to make a cut around the insulation. This type of wire stripper can be used on wires of any size.
hardcore fuck cutefree naked dares hot videossite asstr org mom daughter babysitter threesome f f g

Wire stripper

One of the most underrated tools that all home hobbyists need is a good pair of wire strippers. If you need to just cut wires, there are tools for that but you can get by with just a sharp pocket knife. Wire strippers, however, are designed to remove the insulating sheath from around a wire, which means you need to cut the sheath while leaving the wire itself intact.
spankwire brutal dildos
By using our site, you acknowledge that you have read and understand our Cookie Policy , Privacy Policy , and our Terms of Service. It only takes a minute to sign up. I have been using this wire stripper for a while, but I have always wondered what was the purpose of those holes in the center and above LOOP, and those teeth on the handles. The loop hole is used to bend hooks in wires, so that the wire can be attached to screw terminals. Place the tip of a stripped wire into the hole, and bend the wire around the body of the tool.

About video

All сomments (3)

  • muttadog wrote 13.08.2019, 00:30: #1

    dang u r cute

  • ipfreely wrote 13.08.2019, 01:34: #2

    wow you have a very sexy and very very hot sexy body, could you hold it up right to me?

  • Partyboy89 wrote 14.08.2019, 14:22: #3

    what u gon do wit all that junk!

Say a few words:

Click on the image to refresh the code, if it is illegible

Related Video Trending Now